Your shopping cart is empty!
12mm Heritage Unit Argon Filled - 2.6 Ug Kyrpton filled - 1.9 Ug
14mm Heritage Unit Argon Filled - 2.0 Ug Krypton Filled - 1.5 Ug
16mm Heritage Unit Argon Filled - 1.7 Ug Krypton Filled - 1.2 Ug
Westcountry Heritage Units are super slim, sealed glass units, that offer a modern solution to an old problem, providing excellent performance without compromising a buildings appearance.Produced to order with an authentic appearance, slim sightlines and narrow unit cavities, Westcountry Heritage Insulated Glass Units will compliment listed properties and historic buildings with restoration and replication requirements.
We cannot stress enough the importance of the correct glazing technique for these specialist glass units, to maximise their effectiveness and longevity. All our Westcountry Heritage Units currently have a 2 year guarantee.
Click here to see full glazing instructions!
Only coloured silicone can be used when glazing heritage units- Click here to purchase your putty and silicone
Please allow approximately 3-4 weeks
Choose the shape of the glass
Choose the thickness of the glass
Change the base width of the current shape
Change the height of the current shape
Change the radius of the circle
Change length C of the current shape
Change length D of the current shape
Please note we have a +/- 2mm tolerance all our glass
Krypton Gas provides far superior insulation. Heavier than air, the gases help to maintain a constant temperature in the home as well as offering better soundproofing too.
Remove sharp edges
A smooth, flat edge.
Please note if no polished edges are required edgework quality is not guaranteed.
All over sandblasting added to glass to give a white frosted effect
Sandblasted border added to the glass
A Clear Film applied to the backing of the mirror to help keep the mirror together if it breaks. If you are fixing the mirror with adhesive, please check your adhesive is suitable to use with Safety Backing
For Single panels. The glass will be cut with the pattern in the centre of the glass
For Multiple Panels. Used with panels that are next to each other, so the pattern continues through all the panels. Please note we will require a drawing showing the layout of the panels
An easy clean coating that is applied to the glass that allows water to run off the glass. Most commonly used for shower screens
The minimum drilled hole diameter is 4mm and the maximum is 38mm. Drilled holes cannot be less than the glass thickness. Drilled holes are usually used for fixing holes in glass.
These are circular drilled holes, larger than 38mm. Usually used for Fans, Vents or pet flaps
Curved outer edge on corners. The higher the radius, the greater the curve
An internal section of the glass is cut out to accommodate plug sockets, pipework, hobs, etc.
Please select the RAL colour for your painted glass
You are about to add this custom item to your cart.
Please ensure that your specifications are correct and complete, as UK Glass Centre will not accept responsibility for any errors in data entry.
Note that there are no refunds or replacements for custom items.
0 reviews / Write a review
